Board Layout non-Painted?

rblissett
Topic Author
Offline
New Member

6 years 2 months ago #1270 by rblissett

Board Layout non-Painted? was created by rblissett

Unfortunately had to use the solder sucker on an unevenly mounted SW1 switch. I’m concerned some of the pads on the component side have pulled away. Is there a component side and solder side layout of the actual board so I do some continuity checks to verify all is good. Thx.

Please Log in to join the conversation.

rblissett
Topic Author
Offline
New Member

6 years 2 months ago #1271 by rblissett

Replied by rblissett on topic Board Layout non-Painted?

Was able to use the line drawing and figure it out. See attached image. All seems ok but am replacing C1 as this will be used primarily for bass fun ;-)

So I’ll have to test later. If it’s possible to still post a component and solder side layout of the actual board I’d appreciate it for future troubleshooting. Cheers.

Please Log in to join the conversation.

Ray
Offline
Moderator

6 years 1 month ago #1272 by Ray

Replied by Ray on topic Board Layout non-Painted?

Hi rblissett, here you can see the naked pcb layout and also you can download the PDF:
www.electrosmash.com/forum/pedal-pi/237-...es-and-pcb-transfers