Welcome, Guest
Username: Password: Remember me

TOPIC: Enclosure Design?

Enclosure Design? 6 months 1 week ago #1328

  • BowDown
  • BowDown's Avatar
  • OFFLINE
  • Senior Member
  • Posts: 55
  • Thank you received: 6
  • Karma: 2
Has anyone constructed or 3d printed an enclosure for this pedal?
The administrator has disabled public write access.

Enclosure Design? 6 months 1 week ago #1330

  • BowDown
  • BowDown's Avatar
  • OFFLINE
  • Senior Member
  • Posts: 55
  • Thank you received: 6
  • Karma: 2
Is there room in the Shield PCB Length to shave 1/16th" off each end? I have a near perfect enclosure.. but the Shield PCB is a hair less than 1/8" too long.

Please advise.
The administrator has disabled public write access.

Enclosure Design? 6 months 1 week ago #1341

  • Ray
  • Ray's Avatar
  • OFFLINE
  • Moderator
  • Posts: 519
  • Thank you received: 113
  • Karma: 26
Hi, if you are thinking about using a Hammond 1590B, I have one right here and is it too small and not deep enough (for the shield and for the Arduino MEGA).
Has anyone constructed or 3d printed an enclosure for this pedal?
No, so far nobody did it YET.
Is there room in the Shield PCB Length to shave 1/16th" off each end?
the top of the board is pretty empty, but the OLED connector is just there, maybe if you cut the top and then wire the 4 lines of the OLED display directly to the Arduino Pins you can save that 2 x 1/16th. But it would be messy.

hammondsizechart.jpg


Maybe a 1590N1... I never tried it.
Hammond also makes some transparent plastic enclosures which are easier to cut/shave.
The administrator has disabled public write access.
The following user(s) said Thank You: BowDown

Enclosure Design? 6 months 1 week ago #1342

  • BowDown
  • BowDown's Avatar
  • OFFLINE
  • Senior Member
  • Posts: 55
  • Thank you received: 6
  • Karma: 2
I may end up going the route you described with cutting off the OLED connector and going straight to the pins instead. Thanks for the tip!
The administrator has disabled public write access.
The following user(s) said Thank You: Ray

Enclosure Design? 6 months 5 days ago #1345

  • Ray
  • Ray's Avatar
  • OFFLINE
  • Moderator
  • Posts: 519
  • Thank you received: 113
  • Karma: 26
Yes, you can trim the top of the board and then just connect ground, 5V, SDA(20) and SCL(21) to the OLED.
The administrator has disabled public write access.
Time to create page: 0.095 seconds
Powered by Kunena Forum
Joomla SEF URLs by Artio

Our Instagram

Follow us

You can also follow us on:

facebook   google   instagram

pinterest   youtube   twitter