Enclosure Design?

6 years 7 months ago #1328 by BowDown
Enclosure Design? was created by BowDown
Has anyone constructed or 3d printed an enclosure for this pedal?

Please Log in to join the conversation.

6 years 7 months ago #1330 by BowDown
Replied by BowDown on topic Enclosure Design?
Is there room in the Shield PCB Length to shave 1/16th" off each end? I have a near perfect enclosure.. but the Shield PCB is a hair less than 1/8" too long.

Please advise.

Please Log in to join the conversation.

6 years 7 months ago #1341 by Ray
Replied by Ray on topic Enclosure Design?
Hi, if you are thinking about using a Hammond 1590B, I have one right here and is it too small and not deep enough (for the shield and for the Arduino MEGA).

Has anyone constructed or 3d printed an enclosure for this pedal?

No, so far nobody did it YET.

Is there room in the Shield PCB Length to shave 1/16th" off each end?

the top of the board is pretty empty, but the OLED connector is just there, maybe if you cut the top and then wire the 4 lines of the OLED display directly to the Arduino Pins you can save that 2 x 1/16th. But it would be messy.



Maybe a 1590N1... I never tried it.
Hammond also makes some transparent plastic enclosures which are easier to cut/shave.
Attachments:
The following user(s) said Thank You: BowDown

Please Log in to join the conversation.

6 years 7 months ago #1342 by BowDown
Replied by BowDown on topic Enclosure Design?
I may end up going the route you described with cutting off the OLED connector and going straight to the pins instead. Thanks for the tip!
The following user(s) said Thank You: Ray

Please Log in to join the conversation.

6 years 7 months ago #1345 by Ray
Replied by Ray on topic Enclosure Design?
Yes, you can trim the top of the board and then just connect ground, 5V, SDA(20) and SCL(21) to the OLED.

Please Log in to join the conversation.

5 years 2 months ago #1977 by david.longley@gmail.com
HI there!
I just created one and uploaded to Thingiverse here:
www.thingiverse.com/thing:3899199

Please Log in to join the conversation.

Time to create page: 0.088 seconds
Powered by Kunena Forum
Joomla SEF URLs by Artio