Board Layout non-Painted?

Unfortunately had to use the solder sucker on an unevenly mounted SW1 switch. I’m concerned some of the pads on the component side have pulled away. Is there a component side and solder side layout of the actual board so I do some continuity checks to verify all is good. Thx.

Was able to use the line drawing and figure it out. See attached image. All seems ok but am replacing C1 as this will be used primarily for bass fun So I’ll have to test later. If it’s possible to still post a component and solder side layout of the actual board I’d appreciate it for future troubleshooting. Cheers.

That’s fantastic! Appreciated.