## gadget mode (serial) 1 year 2 months ago #1080

 Mickey OFFLINE New Member Posts: 13 Thank you received: 6 Karma: 1 As processor hogging WiFi is out, I was looking for a way to easily connect to Pedal-Pi while still having some ability to process sound. At first I thought of a serial terminal via the GPIO but the necessary pins are taken. Then I thought of gadget mode. I've set my Pedal-Pi up as a serial gadget using this guide. The only change I made was instead of using a serial cable to enter commands I put this in the crontab @reboot sudo systemctl enable getty@ttyGS0.service Now I can connect to the Pedal-Pi using a standard micro USB cable and PuTTY. The administrator has disabled public write access. The following user(s) said Thank You: Ray

## gadget mode (serial) 1 year 2 months ago #1104

 valvusmusicus OFFLINE New Member Posts: 5 Thank you received: 2 Karma: 0 I followed the instructions in the guide up to the verification step and reboot, but I'm not seeing a new serial port. It seems active when I run: sudo systemctl is-active This email address is being protected from spambots. You need JavaScript enabled to view it., but nothing shows up. I also added your step in the crontab, but for troubleshooting right now I'm still using VNC and wi-fi until I can get it to run serial. Is there something I need to update in Windows to see this in the Device Manager as port 83? Thanks! The administrator has disabled public write access.

## gadget mode (serial) 1 year 2 months ago #1107

 Mickey OFFLINE New Member Posts: 13 Thank you received: 6 Karma: 1 Hi, I'm not sure what the problem is. It just worked for me. I'll see if I can shrink my image down small enough to upload somewhere. Bruce The administrator has disabled public write access. The following user(s) said Thank You: Ray

## gadget mode (serial) 1 year 2 months ago #1108

 Mickey OFFLINE New Member Posts: 13 Thank you received: 6 Karma: 1 Try this image www.dropbox.com/s/mr4h33yvldu2gee/PPGadget.zip?dl=0 it will expand to the full size of the SD card on first boot, give it a few minutes and it should present a serial connection on the USB. Speed 115200 The administrator has disabled public write access.

## gadget mode (serial) 1 year 2 months ago #1109

 valvusmusicus OFFLINE New Member Posts: 5 Thank you received: 2 Karma: 0 Thanks BruceR. I found out the Pi image wasn't the main issue after all. It was communication from my PC. I had to install Bonjour and update the RNDIS drivers which seemed to solve the issue. The administrator has disabled public write access. The following user(s) said Thank You: Ray
Time to create page: 0.133 seconds
Joomla SEF URLs by Artio