Just finished build of my PedalShield DUE

Hello everyone,

After 2 weeks looking for time, I have finally finished mounting my pedalShield.

I leave here some photos. Now let's go through the programming phase and look for some kind of enclosure to make it look nicer.

Well @Ray,

The truth is that I finally dared to make my first 3D design and I already have it done and pending 3D printing in ABS. I hope I have taken the measures well, and it will serve me as an experience.

I leave here the link in case you want to see it. It is very simple and austere, although I hope it will do its job well.

www.thingiverse.com/thing:2203506

Good morning.

I have my first 3D impression here for the enclosure.

I have to file some dots to gain 2mm for the USB connector, I tweak a bit for the top cap of the methacrylate cap, but I think I've tuned it pretty well. I leave you some photos.

Almost finished, in the absence of small details.

Thank you very much. But, well, I had to do some touch-ups by hand with the help of my Dremmel.

To be able to enter properly the slanted plate touched a bit so I have lowered a millimeter an inner part of the box.

I also lowered the opening where the USB port is connected for programming because the connector did not fit well when touching down.

The connection hole of the output jack also had to be retouched. I did not notice that this connector is a millimeter displaced compared to the input.

And finally I made a hole to access the trimmer VR1 because I also did not take into account in the original design.

So I've updated my design on Tinkercad and Thingverse in case it is useful to someone.

www.tinkercad.com/things/cUx6sfmqBcI-pedalshield-case-11

www.thingiverse.com/thing:2219858

Thank you.

I am delighted to contribute to this project.