-
Forum
-
Electro Smash Forum
-
pedalSHIELD UNO
-
Troubleshoot 4.0
Troubleshoot 4.0
Menos
Más
-
Mensajes: 702
-
Gracias recibidas: 152
-
-
6 años 6 meses antes #1049
por Ray
Hi Tesi! well if you have 4.46V at the 2.5V test point the virtual ground of the input stage would be wrong and it wont work
Check:
- Resistors R7 and R8 are likely to be wrong, maybe you placed different values?
- In the image below, make sure that you have the same resistors and voltages
- Make absolutely sure that you have the resistors showed below clean and without shorts, or dry joints (re-solder the joints again!)
Keep us updated with your progress!
Por favor, Identificarse para unirse a la conversación.
Menos
Más
-
Mensajes: 702
-
Gracias recibidas: 152
-
-
6 años 6 meses antes #1059
por Ray
the problem was the resistor R7, now it works!!!
good!!
I still have lot of noise, what about using a power supply with 9V and 1300mA OUTPUT?
Have a look at this (it is for the DUE but essentially you can apply it to the UNO):
www.electrosmash.com/forum/hardware-peda...powering-arduino-due
Regarding your 9V and 1300mA OUTPUT, every power supply is different, some 9V are switch mode power supplies that are pretty noisy.
Por favor, Identificarse para unirse a la conversación.
-
Forum
-
Electro Smash Forum
-
pedalSHIELD UNO
-
Troubleshoot 4.0
Tiempo de carga de la página: 0.082 segundos