- Mensajes: 1
- Gracias recibidas: 0
pedalSHIELD UNO's using the arduino built-in LED
7 años 4 meses antes #676
por Ray
Respuesta de Ray sobre el tema pedalSHIELD UNO's using the arduino built-in LED
Hi, Happy New Year for you too 
The easiest explanation is that you have the LED placed in the "wrong way":
Usually the LED polarity is easy to check just looking at the lenght of the pins but once is place and cut is triky.
The "upper" pin is ground, you can check it with a multimeter and the cathode should be there.
The lower pin is connected through the R9 resistor to an arduino pin, this is the anode.
Looking at this image:
eyewriter.org/images/data/EW-2_0-manual_...led-anode-scheme.jpg
you can see that the cathode, the negative, the "upper pin" connected to ground has the big part of metal inside the plastic cover and yours looks the other way around.
It is pretty simple to de-solder and solder again this part.. in youtube there is plenty of tutorials that can give you some nice visual idea.
Keep us updated with your progress!
The easiest explanation is that you have the LED placed in the "wrong way":
Usually the LED polarity is easy to check just looking at the lenght of the pins but once is place and cut is triky.
The "upper" pin is ground, you can check it with a multimeter and the cathode should be there.
The lower pin is connected through the R9 resistor to an arduino pin, this is the anode.
Looking at this image:
eyewriter.org/images/data/EW-2_0-manual_...led-anode-scheme.jpg
you can see that the cathode, the negative, the "upper pin" connected to ground has the big part of metal inside the plastic cover and yours looks the other way around.
It is pretty simple to de-solder and solder again this part.. in youtube there is plenty of tutorials that can give you some nice visual idea.
Keep us updated with your progress!
Por favor, Identificarse para unirse a la conversación.
Tiempo de carga de la página: 0.073 segundos