Clean effect problems

Hi, have you tried adjusting the VR1 potentiometer? If you have adjusted it with too much gain it could distort the signal.

Hi,

So when you say "everything is working except the clean effect" that means that other effects work but the clean one sounds distorted?
In that case is either the input level is too high (adjusting VR1 should be solved) or the output level is too high (sometimes some guitar amps get a distorted/boosted sound if the output of the pedalshield is too high for them, have you tried in only one amp?)

You can send me a pic of your pedal to my email (below "contact us") to see if I can find something odd.

Hi, I got the message, I will get back to you asap!

Hi, I am trying to find out what can be causing your issue.

If you have a distorted output, it may be due to the VR1 trimmer, if it is not set properly it will amplify the signal too much creating distortion.

If you have a multimeter is important to check that the voltages +5v, - 5v, +3v3 and 1.6v are correct. There are test points on the pcb where you can check those.

There is also a small possibility that the output of the pedal is too high in amplitude for your amp. If you place a 100k resistor from the pin 6 of tge op amp to ground, the output level will be divided by 2.

I am guessing that you dont have access to an oscilloscope, because you can follow the signal flow and check at which point it gets distorted.