Forum
Electro Smash Forum
Pedal-Pi
Enclosure
Enclosure
Menos
Más
Mensajes: 11
Gracias recibidas: 1
4 años 7 meses antes #1964
por ppi
@All,
Which enclosure are your using. I could not find a well-fitting model so far. Anybody having better luck with buying or printing one?
Thanks!
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 702
Gracias recibidas: 152
4 años 7 meses antes #1968
por Ray
The current model includes a laser cut 3mm transparent acrylic plate.
This is the PDF we use to manufacture it:
I'm not aware of any aluminum Hammond enclosure for the pedal pi yet, in Thingiverse there is some stuff for the pedalSHIELD series but nothing for the pedal-pi yet:
www.thingiverse.com/search?q=pedalshield&dwh=945d88d2818e8d5
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 11
Gracias recibidas: 1
4 años 7 meses antes #1969
por ppi
Yes, correct. I got the plate, but it is only a top plate and nothing to protect the solder joints on the bottom. I got a bit scared about that.
If nobody did it yet, I'll look into making a simple bottom part.
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 11
Gracias recibidas: 1
4 años 7 meses antes #1970
por ppi
El siguiente usuario dijo gracias:
Ray
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 702
Gracias recibidas: 152
4 años 7 meses antes #1971
por Ray
Thanks for your contribution, I like it!
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 1
Gracias recibidas: 0
Forum
Electro Smash Forum
Pedal-Pi
Enclosure
Tiempo de carga de la página: 0.060 segundos