- Mensajes: 702
- Gracias recibidas: 152
×
The One Watt Open Hardware Guitar Amplifier.
1Wamp in a 1590B or 1591C Enclosure
8 años 6 meses antes - 5 años 11 meses antes #354
por Ray
1Wamp in a 1590B or 1591C Enclosure Publicado por Ray
The PCB was designed to fit in several enclosures, so if you use it in a rough environment you can protect it easily.
It would fit perfectly tight in a Hammond 1590B, with a bit more room in a 1591C and with plenty of space in any of the bigger boxes like the 125B or the 1590BB.
The 1591B is too small for the PCB. This box is made of plastic and cutting the internal pillars the PCB will finally fit inside but I did not try it yet.
Find below the stencil with the holes placement so you can drill a box easily in a 1590B. Doing it in a similar box is easy too:
These are the top and bottom acrylic plates:
It would fit perfectly tight in a Hammond 1590B, with a bit more room in a 1591C and with plenty of space in any of the bigger boxes like the 125B or the 1590BB.
The 1591B is too small for the PCB. This box is made of plastic and cutting the internal pillars the PCB will finally fit inside but I did not try it yet.
- Hammond 1590B datasheet.pdf
- Hammond 1591C datasheet.pdf
- Enclosure 125B data
- Hammond 1590BB datasheet.pdf
Find below the stencil with the holes placement so you can drill a box easily in a 1590B. Doing it in a similar box is easy too:
These are the top and bottom acrylic plates:
Por favor, Identificarse para unirse a la conversación.
4 años 6 meses antes #2001
por Ray
Respuesta de Ray sobre el tema 1Wamp in a 1590B or 1591C Enclosure
oh sorry, the small holes are for M3 screws (so they should be around 3.1mm holes) and the big ones anything between 5 and 8mm would do. Fortunately, there are not tight tolerances for the big holes. 
Por favor, Identificarse para unirse a la conversación.
Tiempo de carga de la página: 0.061 segundos