Forum
Electro Smash Forum
pedalSHIELD UNO
Help to diagnose my pcb
Help to diagnose my pcb
Menos
Más
Mensajes: 702
Gracias recibidas: 152
5 años 9 meses antes #1474
por Ray
Good to see that you are progressing
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 13
Gracias recibidas: 1
5 años 9 meses antes #1475
por jimt
I am getting some mV on amp
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 702
Gracias recibidas: 152
5 años 9 meses antes - 5 años 9 meses antes #1477
por Ray
I am getting some mV on amp
what do you mean? I do not fully get it
Última Edición: 5 años 9 meses antes por
Ray .
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 13
Gracias recibidas: 1
5 años 7 meses antes - 5 años 7 meses antes #1517
por jimt
Ray escribió:
I am getting some mV on amp
what do you mean? I do not fully get it
I done resoldering again thanks to amtech paste, it was more easier. I am done with this problem I can get 4.92V and 2.431V on test pins.On the other hand, op-amp on 4 and 8 pins gives 0.738V . I also test the buttons with monitor and button switch 1 and toggle switch doesn't work. I test the pedal but gives again a noise without anything else.
Thank you for your time again
Última Edición: 5 años 7 meses antes por
jimt .
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 13
Gracias recibidas: 1
5 años 7 meses antes #1520
por jimt
ok I desolder the socket and solder amp on pcb straight away, now I got 4,85V on pins 4 and 8
lol I am so happy, I will try it now
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 702
Gracias recibidas: 152
5 años 7 meses antes #1523
por Ray
4.81 at 2.5V
check that 2.5V is just a voltage divider, have a close look to that area, without the 2.5V reference voltage the audio won't get through!
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 13
Gracias recibidas: 1
5 años 7 meses antes #1524
por jimt
sorry for my silly response I have this problem too :
"I also test the buttons with monitor and button switch 1 and toggle switch doesn't work"
Por favor, Identificarse para unirse a la conversación.
Menos
Más
Mensajes: 702
Gracias recibidas: 152
5 años 7 meses antes #1529
por Ray
I resolder all components again because two pcb to make double layer is not so easy, because solder doesn't goes on two sides.
yes I know what you mean, I did that before and you have to almost check every single lead to make sure that it is soldered on both sides of the PCB.
Por favor, Identificarse para unirse a la conversación.
Forum
Electro Smash Forum
pedalSHIELD UNO
Help to diagnose my pcb
Tiempo de carga de la página: 0.070 segundos