Greetings. I just ordered a time manipulator kit. Looking through the block schematic and at the populated PCB photos it appears that pins 17,18 & 19 (D11,D12,D13 in Arduino) are unused.
Is it fair to assume those are available for use elsewhere? I was considering adding long jumper wires to those 3 pins, 5v and ground when building my kit so that an additional switch, LED, or maybe a MIDI port could be hacked in later.
Thoughts?
-Andrew
Por favor, Identificarse para unirse a la conversación.
Could you use clk pin 5 from PT2399 to synchronize Delay with tap or midi?
The pin 5 of the PT2399 gives a frequency that is too high to be read by a uC (2 to 20MHz), have a look at the "Pin 5" section of our analysis : www.electrosmash.com/pt2399-analysis
Por favor, Identificarse para unirse a la conversación.